影響環氧地坪漆與混凝土粘結機能的因素有哪些?環氧地坪與混凝土粘結機能的影響因素主要可以分為兩塊：混凝土基面的情況與環氧樹脂地坪的情況。首先應保證環氧樹脂地坪漆能夠與混凝土良好的附著在一起，兩者即不能強力的粘結在一起。也不能有脫落的現象存在，所以我們要嚴格的控制好兩者之間的粘結機能。

What are the factors affecting the bonding function between epoxy floor paint and concrete? The main factors affecting the bonding function between epoxy floor paint and concrete can be divided into two parts: the situation of concrete base and the situation of epoxy floor. First of all, it should be ensured that epoxy floor paint can adhere to concrete well, that is, they can not be strongly bonded together. There can be no shedding phenomenon, so we must strictly control the bonding function between the two. 

一、混凝土基面的情況

I. Conditions of Concrete Foundation

固化環氧地坪程度相宜的粗拙、干燥、堅實的混凝土面為最佳的混凝土基面。

Coarse, dry and solid concrete surface with appropriate degree of solidified floor is the best concrete base surface.

1、含水量：混凝土基面的含水量越低，粘結機能越好。

1. Water content: The lower the water content of concrete base, the better the bonding function.

2、堅實的地面：地面過于疏松，會使環氧地坪漆與基面沒有粘結力。所以在施工前要將疏松層全部去除。

2. Solid ground: The ground is too loose, which will make the floor paint and the base have no bonding force. Therefore, all the loose layers should be removed before construction.

3、多孔性：混凝土作為一種多孔性的地面，內部的毛細管比較適合地坪油漆的浸入。

3. Porosity: As a kind of porous floor, the inner capillary of concrete is suitable for the immersion of floor paint.

地坪漆滲透滲出的越好，兩者的粘結機能越好，所以一般舊的混凝土地面。

The better the penetration and leakage of floor paint, the better the bonding function of the two, so the old concrete floor is generally.

尤其是涂抹過其他遮蓋物的基面，都要經由充分的打磨使其具備一定的粗拙度及地面孔洞開放后進行施工。

Especially the base surface which has been smeared with other covering materials must be fully polished so that it has a certain degree of roughness and openings on the ground for construction.

停車場耐磨地板及耐磨地坪等

Parking lot wear-resistant floor and floor, etc.

二、環氧樹脂地坪材料的情況

II. Situation of Epoxy Resin Floor Materials

1、施工工藝。

1. Construction technology.

當地坪漆與基面的粘接力不足時，地坪會泛起脫落的現象。

When the adhesion between the floor paint and the base is insufficient, the floor will fall off.

而預防脫落最有效的方法就是要留意基面的處理，必須在基面有合適的粗拙、干燥的狀態下才可進行地坪施工。

The most effective way to prevent falling off is to pay attention to the treatment of the base, which must be in a suitable rough and dry condition before floor construction can be carried out.

2、固化反應。

2. Curing reaction.

地坪漆屬于是反應固化型的涂料，在反應過程中放熱的熱量多少和產生的溫度高低都對地坪漆的固化機能有很大的影響。

Floor paint belongs to reactive curing paint. The amount of heat released and the temperature produced during the reaction process have a great influence on the curing performance of floor paint.

其中固化劑是影響固化溫度的主要因素，所以要想保證 環氧樹脂地坪漆與基面的粘結力，必須選擇合適的固化劑。

Among them, curing agent is the main factor affecting the curing temperature, so in order to ensure the bonding strength between epoxy floor paint and the base, it is necessary to select the appropriate curing agent.

環氧樹脂地坪漆是附著在混凝土基面上的一層薄薄的涂膜，要想使它的功能保持得更加良好。

Epoxy resin floor paint is a thin film attached to the concrete base surface, in order to keep its function better.

首先應保證環氧樹脂地坪漆能夠與混凝土良好的附著在一起，兩者即不能強力的粘結在一起。也不能有脫落的現象存在，所以我們要嚴格的控制好兩者之間的粘結機能。

First of all, it should be ensured that epoxy floor paint can adhere to concrete well, that is, they can not be strongly bonded together. There can be no shedding phenomenon, so we must strictly control the bonding function between the two.